HOW TO USE ROCKCHIP BATCH TOOL

From this post we would like to present to you how to Flash stock ROM using Rockchip batch tool. (RK2918, RK3066, RK3188)

• This tool only works for the chipsets that support for the Rockchip tool.
• Before start the process take a proper back up about your device data 
• make sure that your device battery level is between 20-30 percentage.
• Read More : Stock Rom vs Custom Rom
• Read more: Increase Internal Memory Size on your Device

 

Steps for Flashing Stock ROM Using Rockchip Batch Tool

Step 1 :

 Download the Rockchip driver to your PC and install it.

Step 2 :

Download and Extract the Rockchip file. Read More :Rooted and Now what?

Step 3 :

Open the RKbatchtool.exe file

Step 4 :

When utility is launched click the […] button at the right side Conner. Then select the firmware path correctly.

Step 5 :

When you added the path correctly Rockchip will take itautomatically.

Step 6 :

Power off your device and connect it to the PC.

Step 7 :

 Now press volume up button and hold it.then tool can identify your device. Read More : Increase Ram Size on your Device

Step 8 : 

Do not release the volume up button until icon 1 turns to green color.

Step 9 :

Now click the restore button to start the flashing process. (Restore will delete all previous firmware and install a new clean one.. you can also click Upgrade then data will not deleted)

Step 10 :

Now process was began and it will take 3- 4 minutes to complete.

Step 11 :

When the Flashing process was done you can see the done successfully message at the tool. Read More : Enable OTG (pen) on Your Device

Step 12 :

Now click the exit button to exit from the Rockchip batch tool.

Step 13 :

disconnect your device from PC and restart it.

Now your Flashing process was successfully done…..

 

---

 

Frequently Asked Questions Listed Below

 

load firmware failed

first click the switch button then the green will turn to pink and then you can browse the firmware path.. after it loads the firmware.. again click switch then it will turn back to green…once it is green you can press “upgrade” or “restore”

 

Restore Done Success<0> Fail<1> Time<41594>ms

09:13:08 005 <Layer 6-1> Wait For Loader Fail

1. Find another Computer and try.
2. find new USb cable and Try
3. when stopped before appear the error message,  disconnected and re-connected the USB cable (equivalent reset).

Download Boot Fail error

1. Find another Computer and try.
2. find new USb cable and Try
3. Find Fresh Stock Rom.